Want to see the inside of the Xperia Z3? Check out all the pics after the break.
To begin, we need to remove the back cover. To open it, heat the back cover up and then use something like plastic pry bar to remove the cover.
It looks like this when the back has been removed:
The back cover has a foam layer along the edges to keep the phone water resistant.
To remove the battery, disconnect the battery power cable from the plastic strip that has a small amount of glue on it.
To remove the motherboard, remove the screws and a small plastic block.
After then, the motherboard can be removed.
Remove the two screws and the antenna module that integrates the speaker.
A closer look at the 3.5mm headphone jack as well as foam rubbers along the edges.
Removing the 3.5mm headphone jack:
A closer look at the plastic reinforcements that Sony used on the side of the phone.
The touch screen is fixed using a fixed metal ribbon cable:
A closer look at the pipe cooling technology found in Xperia Z3:
Xperia Z3 soft board for integrated side buttons, vibrator, microphone and compass sensor.
Component chip parts used in Xperia Z3: RAM, chipset and internal storage.
Wireless components of the Z3:
And finally here’s all the Z3 components.